System Board - HP xw4200 Service And Technical Reference Manual

System Board

To remove the system board:
1 Disconnect power from the system
workstation on its side with the system board facing up, remove all expansion boards and graphics
cards (page
2 Disconnect all cabling from the system board to disengage the plastic mounting standoffs from the
chassis.
NOTE Make note of the cable connections before disconnecting them from the system board.
3 Press the release tab
4 Slide the board
To replace the system board:
1 Lay the system board back in the chassis slightly away from the rear of the chassis. The mounting
hooks should fall into the recesses of the tray so the tray lays flat on the chassis base.
2 Slide the tray towards the rear of the chassis until the heat sink mounting holes line up.
3 Re-install the heatsink, cards, and cables.
114 REMOVAL AND REPLACEMENT
(page
97), and remove the processor heatsink
1 as shown in the following illustration.
2 toward the front of the chassis and then lift it out of the unit.
1
73), remove the access panel
(page 88).
2
(page 77), lay the