Troubleshooting Using Hp Intelligent Manageability Features - HP xw4200 Service And Technical Reference Manual

Network—Identifies all network devices installed in a system, captures any associated
configuration information, and provides the ability to verify proper operation of these devices. NIC
testing is only performed if drivers are installed during discovery.
Parallel Port—Identifies all parallel devices installed in a system and captures any associated
configuration information. If the parallel port is properly configured and the information is available
to the operating system, the associated DMA, IRQ, and I/O ports are reported. This test
component also provides the ability to verify proper operation of these devices.
PCI Bus—Identifies all PCI devices installed in a system and provides the ability to verify proper
PCI I/O operation to the devices.
Serial Port—Identifies all serial devices installed in a system, captures any associated
configuration information, and provides the ability to verify proper operation of these devices.
Storage—Identifies storage devices connected to a system through IDE, USB, SCSI or a Fibre
Channel network. Supported devices include:
IDE hard disk drives
USB diskette drives
SCSI disk drives
SCSI tape drives
SCSI controllers
RAID controllers
Controllers can be connected to the host through PCI, I2C, or serial port. The component also
captures any associated configuration information, and provides the ability to verify proper
operation of these devices.
Stress—Provides a solution for stress testing hardware in a system.
USB—Identifies all USB devices installed in a system, captures any associated configuration
information, and provides the ability to verify proper operation of these devices.
Graphics—Identifies all graphic devices installed in a system, captures any associated
configuration information, such as the ASIC and monitor types, and provides the ability to verify
proper operation of these devices.
A list of available tests for each test component and a list of error codes can be accessed through the
Test Component and Error Codes menu selections on the Help tab menu bar.
Troubleshooting Using HP Intelligent Manageability
Features
The Local Alert Pop-Up Dialog notifies you of an impending or actual hardware failure. If the workstation
is connect to a network and the HP Insight Management Agents are installed and configured, a Simple
Network Management Protocol (SNMP) trap (message) is sent to the specified SNMP-compliant
management application.
122 SYSTEM DIAGNOSTICS AND TROUBLESHOOTING