Using Computer Setup (F10) - HP xw4200 Service And Technical Reference Manual

Using Computer Setup (F10)

Computer Setup can be accessed only by turning on the workstation or restarting the system. To access
the Computer Setup Utilities menu:
1 Turn on or restart the workstation. If you are in Windows, click Start>Shut Down>Restart the
Computer.
2 Wait for the
prompt, press the F10 key to enter the F10 setup utility.
NOTE If you do not press the F10 key at the appropriate time, you must try again. Turn the workstation
off, then on again, and press the F10 key again to access the utility.
3 Select your language from the list and press Enter. A choice of four headings appears in the
Computer Setup Utilities menu: File, Storage, Security, and Advanced.
4 Use the arrow (left and right) keys to select the appropriate heading. Use the arrow (up and down)
keys to select the option you want, then press Enter.
5 To apply and save changes, select File>Save Changes and Exit.
If you have made changes that you do not want applied, select Ignore Changes and Exit.
To reset to factory settings, select Set Defaults and Exit. This option will restore the original
factory system defaults.
CAUTION Do NOT turn the workstation power OFF while the ROM is saving your Computer Setup F10
changes because the CMOS could become corrupted. It is safe to turn off all power to the workstation
after you exit the F10 Setup screen.
NOTE This menu can change with new firmware releases, so it might be consistent with what is
presented in the following table.
36 SYSTEM MANAGEMENT
prompt to appear on the lower right corner of the screen. Once you see the
F10=Setup