HP xw4200 Service And Technical Reference Manual page 156

To set the SCSI ID on a drive, refer to the instructions on top/back of the hard drive for the correct jumper
settings. The drive probably displays a diagram of the jumper block. This diagram shows you which
blocks to cover with your jumper to get the desired ID.
For example, if the drive needs to be set to 3, the drive might show that the 3 ID bits are at the far left of
the connector (ID0, ID1, ID2, and ID3), then using the jumpers provided, cover each block to set the
SCSI ID.
NOTE After changing the jumper settings, reboot the workstation to recognize the new address.
156 SCSI DEVICES