Special Handling Of Components - HP xw4200 Service And Technical Reference Manual

NOTE Metric screws have a black finish. American National (unified) screws have a silver finish.
NOTE As each subassembly is removed from the workstation, place the subassembly away from the
work area to prevent damage.
If necessary, additional drive guide screws are provided on the system chassis. There are eight Metric
screws located on the chassis near the 5.25-inch optical drive bays. These screws can be used to
mount additional optical drives or an optional diskette drive. There are four American National screws
located on the chassis near the hard drive. These screws can be used to mount additional hard drives in
the 3.5" hard drive cage. For more information about this procedure, see
5.5" slot (Optional)" on page
NOTE The Metric (black) and American National (silver) screws are not interchangeable.
1 Metric screws (8)
2 American National screws (4)

Special Handling of Components

The following components require special handling when servicing the workstation.
WARNING! Do not use the front bezel as a handle or lifting point when lifting or moving the workstation.
Lifting the workstation from the front bezel or lifting it incorrectly could cause the unit to fall and cause
harm to the user and damage to the workstation. To properly and safely lift the workstation, lift it from the
bottom of the unit from either the desktop or minitower configuration.
112.
"Installing Hard Drives in the
1
2
SERVICE CONSIDERATIONS 71