System Fan - HP xw4200 Service And Technical Reference Manual

System Fan

To remove the system fan:
1 Disconnect power from the system
2 Disconnect the fan connector
3 Remove the four screws
4 Slide the fan
To replace a system fan, reverse the previous steps.
CAUTION When installing the system fan, ensure that the fan is situated so that the airflow direction is
going out of the chassis.
NOTE This system only supports 4-wire fans.
86 REMOVAL AND REPLACEMENT
(page
1 from the system board.
2 from the back of the chassis back panel with a Phillips screwdriver.
2
1
3 toward the front of the unit and remove it.
73) and remove the access panel
3
(page 77).