System Board - HP 200 G1 ST Maintenance And Service Manual

System board

NOTE: System board appearance may vary.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the memory modules
4. Disconnect the following cables from the system board, noting their location for reinstallation:
(1): Fan
(2): Front I/O assembly
(3): Front I/O assembly
(4): Front I/O assembly
(5): Optical drive data
(6): Hard drive data
(7): Power switch
(8): Hard drive power
(9): Optical drive power
5. Remove the four Torx T15 screws (1) that secure the system board to the chassis.
(Preparation for disassembly on page
(Access panel on page 15).
(Memory on page 17).
14).
System board 23