Front Bezel
To remove the bezel:
1
Disconnect power from the system
2
Lift up on the two tabs
3
Rotate the front bezel
bezel.
Bezel Blanks
To remove the bezel blanks:
1
Disconnect power from the system
bezel. After removing the front bezel, gently pull the subpanel 1, with the bezel blanks secured in it,
away from the front bezel.
2
Remove the desired bezel blank
NOTE
The bezel blanks are keyed to assist you in replacing the blanks. Also, the subpanel can be
rotated 90 degrees to install the optical drives in desktop orientation, if desired.
80 REMOVAL AND REPLACEMENT
(page
73) and remove the access panel
1
located on the front bezel.
2
away from the chassis as shown in the following illustration and remove the
2
(page
73), and remove the access panel
2
by pulling the blank away from the subpanel.
1
1
2
(page
77).
(page
80) and front