HP xw4200 Service And Technical Reference Manual page 99

PCI or PCI Express Installation
To install a PCI or PCI Express card:
1 Disconnect power from the system
workstation on its side with the system board facing up, and remove the PCI retainer
2 Lift the PCI levers 1 by first pressing down on them and then out.
3 Remove the PCI slot cover 2.
4 Install the PCI card (3, left) or PCI Express card (3, right) into the chassis. Verify that the keyed
components of the card align with the PCI socket. If installing a PCI Express card, plug in the power
supply cable, if required.
5 Close the PCI levers 4. If the PCI levers do not close, be sure all cards are properly seated and then
try again.
6 If installing a PCI Express card, plug in the power supply cable 5, if required.
1
1
2
Figure 4-2
PCI card installation (left) and PCI Express Card Installation (right)
(page 73), remove the access panel
4
3
4
(page 77), lay the
2
1
1
5
REMOVAL AND REPLACEMENT OF COMPONENTS 99
(page 97).
4
4
3