Table of Contents
Advertisement
Diskette data cable
Diskette data connector
FIGURE 9-14
9.6.2
Replacing the Diskette Data Cable
1. Route the replacement diskette data cable in the same manner as the defective
cable that you just removed.
The cable should run under the first metal cable clip in the chassis floor.
2. Connect the diskette data cable to its connector on the system board.
See Section 9.3.2 "Replacing the Diskette Drive" on page 9-11.
3. Install the diskette drive.
See Section 9.3.2 "Replacing the Diskette Drive" on page 9-11.
4. Connect the DC power harness (labeled P3) and the new diskette data cable to the
diskette drive.
5. Install the CD-ROM drive (if necessary).
See Section 9.2.2 "Replacing the CD-ROM Drive" on page 9-6.
Diskette Data Cable Routing
Chapter 9
Storage Devices
9-17
Advertisement
Table of Contents
Troubleshooting
