5. Remove the diskette drive cable assembly.
8.4.4
Replacing the Diskette Drive Cable Assembly
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
1. Position the diskette drive cable assembly into the chassis.
2. Connect the following:
a. Replace the diskette drive cable connector to the motherboard.
b. Replace the diskette drive cable into the plastic spring clips installed adjacent
to the drive bay.
c. Replace the diskette drive cable connector to the diskette drive.
d. Connect the SCSI cable to the CD-ROM drive (or tape drive).
e. Replace the drive tray.
See Section 9.2.6 "Replacing the RMA" on page 9-8.
3. Connect the AC power cord.
4. Detach the wrist strap.
5. Replace the side access cover.
See Section 7.3 "Replacing the Side Access Cover" on page 7-5.
6. Power on the system unit.
See Section 6.1 "Powering On the System Unit" on page 6-1.
8.4.5
Removing the UPA Graphics Card
Cable Assembly
1. Power off the system unit.
See Section 6.2 "Powering Off the System Unit" on page 6-3.
2. Disconnect the video cable from the graphics card video connector.
Chapter
-13