Cd-Rom Audio Cable; Removing The Audio Cable; Figure 9-15 Audio Cable Connector On The Cd-Rom Drive - Sun Microsystems SPARCstation 4 110 Service Manual

6. Detach the wrist strap and replace the cover.
See Chapter 7.
7. Power on the system.
See Section 6.2 "Powering On the System" on page 6-4.
9.7

CD-ROM Audio Cable

9.7.1

Removing the Audio Cable

1. Shut down and power off the system.
See Section 6.1 "Powering Off the System" on page 6-1.
2. Remove the cover and attach a wrist strap.
See Chapter 7.
3. Remove the SBus card (if present).
See Section 11.1.1 "Removing the SBus Card" on page 11-2.
4. Unplug the CD-ROM audio cable from the back of the CD-ROM drive.
See
FIGURE 9-15
CD-ROM audio
cable connector
FIGURE 9-15
5. Free the audio cable from the slot on the side of the Audio Module, and from
under the retaining hooks on the board guide.
See
FIGURE 9-16
9-18 SPARCstation 4 Model 110 Service Manual • July 1996
.
Audio Cable Connector on the CD-ROM Drive
.