Vsimm; Removing The Vsimm; Figure 11-22 Installing The Dsimm - Sun Microsystems SPARCstation 4 110 Service Manual

FIGURE 11-22
6. Detach the wrist strap and replace the cover.
See Chapter 7.
7. Power on the system.
See Section 6.2 "Powering On the System" on page 6-4.
8. Watch for the system banner to verify that the system recognizes the new memory.
The system banner appears at the top of the screen a few seconds after you power on
the system. Check the amount of memory listed in the system banner to verify that
the system recognizes the new memory.
11.4

VSIMM

11.4.1

Removing the VSIMM

1. Shut down and power off the system.
See Section 6.1 "Powering Off the System" on page 6-1.
11-20 SPARCstation 4 Model 110 Service Manual • July 1996
Push the DSIMM
firmly into its connector.
Installing the DSIMM