Figure 9-2 Removing The Hard Disk Drive - Sun Microsystems SPARCstation 4 110 Service Manual

FIGURE 9-2
9.1.2 Replacing the Hard Disk Drive
Note – No jumper settings are required for the hard drive. The SCSI ID and
termination are provided by the system board.
1. Remove the replacement drive from its antistatic shipping bag.
2. Release the handle latch near the rear of the drive and lift the handle until it is in
the vertical position.
3. Grasp the drive bracket handle with one hand; with your other hand, hold the
drive steady. Maintain the drive in a horizontal position and lower it into the
drive bracket.
See
FIGURE 9-3
rail mounting slots.
4. Connect the disk drive SCSI cable to the rear of the drive and to the system board
disk drive connector.
Removing the Hard Disk Drive
. Make sure that the drive is properly seated in the drive bracket side-
Chapter 9 Storage Devices 9-3