Removing The Audio Module; Figure 11-9 Removing The Audio Cable From The Audio Module - Sun Microsystems SPARCstation 4 110 Service Manual

11.2.1

Removing the Audio Module

1. Shut down and power off the system
See Section 6.1 "Powering Off the System" on page 6-1.
2. Remove the cover and attach a wrist strap.
See Chapter 7.
3. Remove the SBus card (if present).
See Section 11.1.1 "Removing the SBus Card" on page 11-2.
4. Free the audio cable from the cable slot on the side of the board, and from the
retaining hooks on the card guide.
See
FIGURE 11-9
5. Unplug the audio cable from the connector on the Audio Module.
Gently pull the audio cable from underneath the Audio Module metal shield, so that
the connector does not snag on any Audio Module component.
Cable slot
Metal
shield
FIGURE 11-9
11-8 SPARCstation 4 Model 110 Service Manual • July 1996
.
Removing the Audio Cable From the Audio Module
Retaining hooks
Taped cable section
Audio cable connector