Table of Contents
Advertisement
a. Insert the front edge of the board (the edge with the DSIMMs) into the card
guide.
b. Lift the rear panel of the board slightly to make sure that the "foot" on the
underside of the board doesn't catch the metal edge of the chassis.
c. Slide the board along the card guide until it is fully inserted.
Installing the System Board
FIGURE 11-30
2. Tighten the two captive Phillips screws that secure the board to the rear of the
chassis.
Do not overtighten these screws.
Chapter 11
System Board and Component Replacement
Card guide
System board
11-27
Advertisement
Table of Contents
Troubleshooting
