Xerox Phaser 8400 Service Manual page 85

Error Code Definition Table (Continued)
Error code
8,035.4x
CAP_FAULT_MOVEUP_STALL
8,045.4x
CAP_FAULT_MOVEDOWN_ST
ALL
8,055.4x
CAP_FAULT_ENGAGING_STA
LL
8,000.6x
CAP_PROG_FAULT
9,000: INK LOADER: INK MELTERS AND PRINTHEAD INK-LEVEL SENSORS.
9,000.4x:
IL_FAULT_NONE
9,005.4x
IL_FAULT_C_JAM
9,006.4x
IL_FAULT_M_JAM
3-18
Definition
The media path drive module has stalled while moving the
wiper up.
1. Run the Head Maintenance Clutch test, replace the
wiper drive clutch if the test fails.
2. Run the Wiper Drive test. Replace the maintenance
drive if the test fails.
The media path drive module has stalled while moving the
wiper up.
1. Run the Head Maintenance Clutch test, replace the
wiper drive clutch if the test fails.
2. Run the Wiper Drive test. Replace the maintenance
drive if the test fails.
The media path drive module has stalled while engaging
the headtilt.
1. Run the Head Maintenance Clutch test, replace the
wiper drive clutch if the test fails.
2. Run the Wiper Drive test. Replace the maintenance
drive if the test fails.
This indicates a code firmware fault within the head
maintenance system.
1. Reset NVRAM, and retest.
This indicates a fault code related to the ink loader
subsystem.
This fault code indicates a problem with the Ink Load sub-
system. The cyan ink melt heater is on, but ink does not
seem to be dripping.
1. Check that the ink stick is able to advance in the
chute. Open the ink door and wiggle the ink sticks.
2. Run the Ink Melt 2 Heaters test.
3. If the test passes replace the printhead.
4. If the test fails, replace the ink loader assembly and
door.
This fault code indicates a problem with the Ink Load sub-
system. The magenta ink melt heater is on, but ink does
not seem to be dripping.
1. Check that the ink stick is able to advance in the
chute.
2. Run the Ink Melt 3 Heaters test.
3. If the test passes replace the printhead.
4. If the test fails, replace the ink loader assembly and
door.
Phaser 8400 Printer Service Manual