Pick Assembly - Xerox Phaser 8400 Service Manual

Pick Assembly

(PL 3.12)
1. Remove Tray 2 from the printer.
2.
Reach into the tray cavity and release the green colored catch holding the Pick
Roller in place. The catch is located on the ceiling of the tray cavity about 1/4 of
the way across the unit from the right side and about 5 inches (12.5 cm) back.
When you pull forward on the catch, the roller will swing down.
1
2
3. Pull down to remove the roller.
Note
Replace the Retard Roller (see following figure) at the same time you
replace the Pick Assembly.
Replacement Notes:
Note
Insert the replacement with the metal shaft at the top and toward the left, the
grey rollers should be facing you. Position the roller back about 2 inches
(5 cm) in the tray cavity, feel for a large plastic clip on the right and the
mating gear for the Pick Assembly on the left. Rotate the Pick Assembly up
and back to latch it in place.
8-40
s8400-171
Phaser 8400 Printer Service Manual
s8400-172