Xerox Phaser 8400 Service Manual page 144

Jam Code Troubleshooting Procedures
Z3V Tray 4 Pick Flag Sensor Timed Out While Print Drum Maintenance Cycle Being
Peformed
1. Verify the paper loaded in Tray 4 is the correct size and type.
2. Inspect/clean the pick roller assembly. Replace if necessary.
3. Run diagnostic Check Shafts Tray 4 Pick Shaft test
4. Replace the Tray 4 535-sheet feeder.
Z3W Tray 4 Pick Flag Sensor Timed Out While Printer Imaging
1. Verify the paper loaded in Tray 4 is the correct size and type.
2. Inspect/clean the pick roller assembly. Replace if necessary.
3. Run diagnostic Check Shafts Tray 4 Pick Shaft test
4. Replace the Tray 4 535-sheet feeder.
Z3S Tray 4 Pick Flag Sensor Timed Out While Paper Staged for Print
1. Verify the paper loaded in Tray 4 is the correct size and type.
2. Inspect/clean the pick roller assembly. Replace if necessary.
3. Run diagnostic Check Shafts Tray 4 Pick Shaft test
4. Replace the Tray 4 535-sheet feeder.
Z3T Tray 4 Pick Flag Sensor Timed Out While Transfixing the Print
1. Verify the paper loaded in Tray 4 is the correct size and type.
2. Inspect/clean the pick roller assembly. Replace if necessary.
3. Run diagnostic Check Shafts Tray 4 Pick Shaft test
4. Replace the Tray 4 535-sheet feeder.
Z3Z Tray 4 Pick Flag Sensor Timed Out While Exiting Print
1. Verify the paper loaded in Tray 4 is the correct size and type.
2. Inspect/clean the pick roller assembly. Replace if necessary.
3. Run diagnostic Check Shafts Tray 4 Pick Shaft test
4. Replace the Tray 4 535-sheet feeder.
Error Messages and Codes
(Continued)
3-77