Xerox Phaser 8400 Service Manual page 211

Electronics Troubleshooting Guide
Customer Please see chapter 4 of service manual
network or for procedures related to communication
printer's problems.
Ethernet
port not
properly
configured
Printer Use the front panel hidden service menu
internal to reset NVRAM
settings
corrupted
Perform full test of printer
Printer Transient on Cycle power to ensure printer initializes
resets AC line during stable AC power
unexpe tripped
ctedly reset
circuitry in
printer
Internal fault Record any error codes and report to
Xerox Office Group
Printer Model not Use the front panel to enable Energy Star
fails to certified as mode (Printer Setup -> Printer Control ->
enter an Energy Select Power Saver Timeout)
Energy Star model
Star
mode
4-66
* Possible solution to
problem *
* Possible solution to
problem *
If the printer detects
an error, the printer
will attempt to correct
the problem by
rebooting and
reinitializing (for up to
three times). After
the third cycle of
rebooting, an error
code will be
displayed on the LCD
and flashed on the
PS and PE indicators
Many printers are not
shipped as Energy
Star compliant and
don't have the power
saving mode enabled
by default
Phaser 8400 Printer Service Manual