Xerox Phaser 8400 Service Manual page 139

Jam Code Troubleshooting Procedures
Y2L Tray 4 media size sensor unexpectedly activated while printer in standby
Y2M Tray 4 media size sensor unexpectedly activated while pick from Tray 2
Y2N Tray 4 media size sensor unexpectedly activated while pick from Tray 3
Y2P Tray 4 media size sensor unexpectedly activated while pick from Tray 4
Y2Q Tray 4 media size sensor unexpectedly activated while pick from Tray 1
Y2R Tray 4 media size sensor unexpectedly activated while duplexing
Y2V Tray 4 media size sensor unexpectedly activated while print drum maintenance
cycle being peformed
Y2W Tray 4 media size sensor unexpectedly activated while printer imaging
Y2S Tray 4 media size sensor unexpectedly activated while paper staged for print
Y2T Tray 4 media size sensor unexpectedly activated while transfixing the print
Y2X Tray 4 media size sensor unexpectedly activated while exiting print
Y3D Tray 4 media size sensor unexpectedly activated timeout during warmup
1. Ensure the Tray 4 paper guides are correctly set.
2. Run the diagnostic Monitor Sensors test to test the media size sensors.
3. Inspect the connector between the 525-sheet feeder (Tray 4) and the printer.
4. Replace the Tray 4 525-sheet feeder
Y3E Tray 4 timeout during printer ready
1. Ensure the Tray 4 paper guides are correctly set.
2. Run the diagnostic Monitor Sensors test to test the media size sensors.
3. Inspect the connector between the 525-sheet feeder (Tray 4) and the printer.
4. Replace the Tray 4 525-sheet feeder
Y3F Tray 4 timeout while printer in fault state
1. Ensure the Tray 4 paper guides are correctly set.
2. Run the diagnostic Monitor Sensors test to test the media size sensors.
3. Inspect the connector between the 525-sheet feeder (Tray 4) and the printer.
4. Replace the Tray 4 525-sheet feeder
Y3L Tray 4 timeout while printer in standby
1. Ensure the Tray 4 paper guides are correctly set.
2. Run the diagnostic Monitor Sensors test to test the media size sensors.
3. Inspect the connector between the 525-sheet feeder (Tray 4) and the printer.
4. Replace the Tray 4 525-sheet feeder
Y3M Tray 4 timeout while pick from Tray 2
1. Ensure the Tray 4 paper guides are correctly set.
2. Run the diagnostic Monitor Sensors test to test the media size sensors.
3. Inspect the connector between the 525-sheet feeder (Tray 4) and the printer.
4. Replace the Tray 4 525-sheet feeder
3-72
(Continued)
Phaser 8400 Printer Service Manual