Table of Contents
Advertisement
7
Maintenance
This equipment contains hazardous voltages and controls hazardous rotating mechanical parts.
Switch off and disconnect the Cycle from the mains supply before carrying out any maintenance procedures.
NEVER switch on the cycle while the side panels are removed.
ALWAYS replace faulty/damaged parts with new genuine Pulse Fitness parts and never use the Pursuit / Perform Cycle until the
machine has been fully repaired.
7.1
Routine Maintenance - Daily
Wipe down the Pursuit / Perform Cycle's side panels, seat, console and hand grips everyday using a mild soap solution on a damp cloth.Wipe dry with a
soft cloth. In addition to this, spray the metal frame (but not the control panel) with a proprietary silicone-based polish and wipe off with a dry soft cloth.
NOTE: Do not clean the frame with water-based solutions.
Routine Maintenance - Weekly
Thoroughly clean the entire machine using the same cleaning methods as for the Daily Clean. Inspect the frame for rust, bubbling or paint chips.
NOTE: This check is important as perspiration will corrode damaged or unpainted surfaces very quickly.Therefore this maintenance check will help to
maintain the clean and professional appearance of your machines.
Do not clean the frame with water-based solutions.
Routine Maintenance - Quarterly
Because of the amount of pressure which is exerted onto the cycles through heavy exercising, it is possible (although unlikely) for fasteners to become
loose.Therefore it is necessary to do a visual or tool check with the necessary spanners or allen keys that all following nuts and bolts are tight;
Feet Strut Nuts & Bolts, Handle Bar Bolts, Console Bolts, Seat Pad Bolts, Pedal Arm Bolts, Condition of Seat, Condition of Handlebars.
Regularly check the machine for damage, wear, general smooth and safe operation. DO NOT use the machine if any part appears
worn, damaged or faulty.
WARNING
WARNING
33
Advertisement
Table of Contents
