Programming Using The 5655 Silent Knight Software Suite-2; Programming Using An Annunciator; Entering & Exiting Panel Programming; Moving Through The Menus - Honeywell SILENT KNIGHT RPS-2000 Installation And Operation Manual

8.3 Programming Using the 5655 Silent Knight
Software Suite-2
You can use the 5655 Silent Knight Software Suite (SKSS-2) to program the control panel
onsite or remotely (personnel will need to be onsite during the upload or download process).
SKSS-2 is a software package that lets you easily program the control panel using a Windows-
based computer and a modem* (not sold by Silent Knight). SKSS-2 is needed for Site/
Networking Mapping. When using SKSS-2, you can set up the programming options for the
panel, save the options in a file, then download the file to the panel. You connect to the control
panel directly using the onboard USB or remotely using a modem
See Table 1-3 for a list of modems that have been tested for compatibility with the control
panel and SKSS-2.
8.4

Programming Using an Annunciator

Many of the IFP-2000 features can be programmed through the system annunciator, using
either the control panel's on-board annunciator or a RA-2000 remote annunciator.
The following subsections describe programming basics, including a description of editing
keys available for programming and how to move through programming menus. Section 9
contains specific information about individual programming options.
8.4.1 Entering & Exiting Panel Programming
To enter Program Mode:
1. Enter the Installer Code (factory programmed default code is 123456).
2. Then press . The programming menu option displays. See Section 9 for detailed menu
7
information and Section 8.5 for a quick reference listing all programmable options and
JumpStart defaults.
To exit Program Mode:
When you have completed working with the menus, press
you are exited from programming mode. Two prompts will display. The first prompt is to
make sure you intended to leave the panel programming (select Yes or No as appropriate). The
second prompt is for accepting all changes. If you select No, any changes you have made
since you entered panel programming will have no effect.

8.4.1.1 Moving through the Menus

Figure 8-9 shows how to move through the menu screens, using the main menu screen as an
151430
firealarmresources.com
Programming Overview
(left arrow) several times until
8-13