Table of Contents
Advertisement
Fire/Security Applications
4.4.4 Programming
The control panel can communicate with any number of security devices. To do so, program the
points as follows:
1.
Select the address of the module(s) to be used for security.
2.
Select the Type Code
NOTE: For detailed instruction on programming Type Codes, refer to the XLS140 Programming
Manual.
4.4.5 Wiring for Proprietary Security Alarm Applications
Table 4.4 shows typical wiring for proprietary security alarm applications with XLS-MM-A/
TC809A1059 modules. Note the following:
•
The module is programmed with software
•
Supplementary use only applies to UL-listed systems.
•
NAC devices used for security cannot be shared with fire NAC devices.
•
Refer to the Device Compatibility Document for compatible NAC devices.
•
All monitor modules used for security application must be installed in the XLS140 cabinet
with STS-1 Security Tamper Switch.
UL-listed 47K
End-of-Line Resistor
(provided with module)
Figure 4.4 Wiring Diagram for Proprietary Security Alarm Applications
XLS140 Installation Manual Form Number 95-7673-3 P/N 51927:C 12/06/2005
.
SECURITY
XLS140 Protected Premises Unit
UL-listed,
normally-open
security switch
UL-listed, normally-closed
security switch
(Note: TC809A1059 has same connections)
Type Code.
SECURITY
9
0
7
8
9
6
10
5
11
4
8
1
12
3
13
2
1
14
0
15
7
2
TENS
7
8
6
9
5
6
3
4
3
2
1
5
4
0
ONES
ADDRESS
LOOP
XLS-MM-A
Applications
SLC
–
Channel
A or B
+
63
Hide quick links:
Advertisement
Table of Contents
