Table of Contents
Advertisement
6.2.2.2 Edit Site Name
2
5. Press
to edit the site name press. See Figure 6-2
6.2.3
Edit Panel ID
This menu option allows you to change the current Network Panel ID. It is best to carefully
consider the network ID setting for each panel. Take into account any future panels that will
be added to the network (future wiring of two buildings together...). The Network Panel ID
setting has to be unique for each panel on the network.
This menu will allow you to change the currently assigned Network Panel ID to the current
Network ID dip switch setting. The system will be down as the panel needs to reboot in order
to complete the transition.
After running Jumpstart Auto-programming for the first time or using the Download software
to program the panels, the Network Panel ID will be locked from future editing. The only was
to change it will be to restore defaults and use this menu again.
To Edit the Network Panel ID:
1. Enter the installer code. The panel will automatically go to the main menu.
6
2. Select
for Network Programming
3
3. Press
to enter the Edit Panel ID Menu
4. If the Network Panel ID is changed and valid, the system will ask you to confirm the
change. If it is not correct, you can change the dip switches at this time.
5. Press up to select YES and press
6.2.4
Computer Account
An installer at the panel site can initiate communications between the panel and a computer
151430
Figure 6-2 Site Assignment
to confirm.
firealarmresources.com
Network Management
6-3
Advertisement
Table of Contents
Troubleshooting
