Substream 1; Substream 2 - Canon CR-N300 Settings Manual

[Bit Rate Control]
Settings for the video bit rate.
In order to control the bit rate strictly in an environment subject to limitations such as the bandwidth, set to [CBR].
[Target Bit Rate (Mbps)]
Enter the target value of the bit rate when [Bit Rate Control] is set to [CBR].
Enter a bit rate as an image quality target when [Bit Rate Control] is set to [VBR]. Depending on the video, the set bit rate
may be exceeded.
The maximum value that can be entered differs depending on the settings of [Video Size] and [Framerate (fps)].
[I Frame Interval (sec.)]
Select the interval in seconds to insert an I frame into the video selected in [Video Codec]. Specify [ALL-I] if wanting all
frames to be I-frames.
Note
When [Video Codec] is set to [H.265], [ALL-I] cannot be set.

Substream 1

Settings for the video of Substream 1 to be distributed from the camera.
[Video Codec]
H. 264 is fixed.
[Video Size]
640 x 360 is fixed.
[Framerate (fps)], [Bit Rate Control], [Target Bit Rate (Mbps)], [I Frame Interval (sec.)]
Refer to each item of [Mainstream].
Note
[Framerate (fps)] of Substream 1 cannot be set to [59.94] or [50.00].

Substream 2

Settings for the video of Substream 2 to be distributed from the camera.
[Video Codec]
JPEG is fixed.
[Video Size]
1280 x 720 is fixed.
[Framerate (fps)]
The set value is displayed according to the frame frequency.
53