Table of Contents
Advertisement
[System] > [Server] > [RTP]
Settings for video and audio streaming using RTP.
RTP Server
Settings for use of RTP, RTSP authentication method and port number.
[RTP]
Select whether to use RTP.
[RTSP Authentication Method]
Select a RTSP authentication method. Since RTSP authentication method is set independently from HTTP Server
authentication method, it is necessary to configure the setting for each authentication method.
[RTSP Port]
Enter the RTSP port.
In general, use [554] (factory default settings).
Audio Settings
Settings for multicast audio transmission.
[Audio Compression Method]
Displays the audio compression method and the frequency. [AAC-LC 48kHz] as fixed value.
[Multicast Address]
Enter multicast address for audio transmission as follows.
IPv4: in the range of 224.0.0.0 to 239.255.255.255
IPv6: address starting with ff00::/8
[Multicast Port]
Enter multicast port for audio transmission.
[Multicast TTL]
Enter the effective range for multicast distribution.
The TTL (Time To Live), representing the effective range for multicast distribution, is decremented each time the signal
passes through a router. When it reaches 0, distribution through a router becomes impossible.
For example, if TTL is set to [1], multicast distribution is confined to the local segment only and cannot pass through the
router.
Note
With one of the following settings, audio multicast distribution is disabled.
– Set [0.0.0.0] (IPv4) or [::0(::)] (IPv6) for [Multicast Address] .
– Set [0] for [Multicast Port] or [Multicast TTL].
57
Hide quick links:
Advertisement
Table of Contents
