Rtp Mainstream, Rtp Substream 1, Rtp Substream 2 - Canon CR-X300 User Manual

RTP Mainstream, RTP Substream 1, RTP Substream 2

Settings for each stream for RTP stream distribution.
[Video Type]
Displays [Video Codec] and [Video Size] set for each video stream in [System] > [Video and Audio] > [IP Streaming Video].
[Multicast Address]
Enter multicast address for RTP stream as follows.
IPv4: in the range of 224.0.0.0 to 239.255.255.255
IPv6: address starting with ff00::/8
[Multicast Port]
Enter multicast port for RTP stream.
[Multicast TTL]
Enter the effective range for multicast distribution of RTP stream.
The TTL (Time To Live), representing the effective range for multicast distribution, is decremented each time the signal
passes through a router. When it reaches 0, distribution through a router becomes impossible.
For example, if TTL is set to [1], multicast distribution is confined to the local segment only and cannot pass through the
router.
[Audio Transmission]
Select whether to use the audio transmission of RTP stream.
When [Disable] is set for [System] > [Video and Audio] > [Audio] > [General Audio] > [Audio Input], [Enable] cannot be set.
Note
• With one of the following settings, the multicast distribution of RTP stream is disabled.
– Set [0.0.0.0] (IPv4) or [::0(::)] (IPv6) for [Multicast Address].
– Set [0] for [Multicast Port] or [Multicast TTL].
• URL for RTP stream
rtsp://IP address: port/rtpstream/config1(to 3)
Example: rtsp://192.168.100.1:554/rtpstream/config1
– Distribution method depends on the request for distribution from the RTP client application.
– config1 requests the distribution of RTP Mainstream, config 2 requests RTP Substream 1, and config 3 requests RTP Substream 2.
• Video quality of Main and Sub1 with [Bit Rate Control], etc. uses the settings in [System] > [Video and Audio] > [IP Streaming Video]
(P. 56) .
• [Video Distribution] in [System]> [Security]> [User Management]> [User Authority] is not reflected in RTP.
• In an environment using proxy server or firewall, the video from the RTP stream may not be displayed. In such a case, contact your
system administrator.
• When the host access restriction is applied to a client during the RTP over UDP stream distribution, it may take from a few seconds to
several tens of seconds to stop the distribution.
61