[System] > [Communication] > [External Connection (Serial)]; Serial Port - Canon CR-N300 Settings Manual

[System] > [Communication] > [External Connection
(Serial)]
Settings for communication by the serial connection of controllers, etc.
Note
Connect the Remote Camera Controller RC-IP100 via IP. This camera cannot be controlled by the serial connection.

Serial Port

Detail settings for the serial port.
[Serial Port]
Select whether to use the serial port.
[Serial Port Connection Type]
RS-422 as fixed value.
[Baud Rate (bps)]
Select the Baud Rate value.
[Data Length (bit)]
Data length of serial communication is fixed at 8 bit.
[Start Bit (bit)]
The length of the start bit is fixed at 1 bit.
[Stop Bit (bit)]
The length of the stop bit is fixed at 1 bit.
[Parity]
The settings for the error detection code is fixed to None
Note
In the next item, if the [Standard Communication (Serial)] is set as [Enable], the settings for the baud rate of the serial communication, data
length, stop bit, and parity will be changed as follows.
– Baud rate : Speed of Standard Communication (Serial)
– Data length (bit) : 8
– Stop bit (bit) : 1
– Parity : None
66