Furuno Felcom 15 Operator's Manual page 104

4. INMARSAT C COMMUNICATIONS
Display log printout example ("Confirmation" ON, delivery status not received)
Transmitting a message to a station not registered on station list
1. Prepare message. For e-mail, set Text Mode in the Editor Setup menu to
Ascii. See paragraph 3.2.3. For e-mail attachment, prepare the attachment
and save it to a floppy disk.
2. Press the [F3] key to display the Transmit menu.
3. Press the [1] key to show the Transmit Message menu.
File
---- * ---------+---------+---------+---------+---------+---------+---------<
4-8
TRANSMIT MESSAGE STATUS
The terminal unit displays transmit message status as follows:
Message Send failed. This appears if the message could not
be transmitted because of technical reasons such as satellite
malfunction, signal degradation, or no reply from LES. Try to
transmit the message again.
Message Send rejected. This appears when the LES rejects
the message because of non-technical reasons such as unpaid
subscriber's fee.
Message Send pending.This appears when the circuits at the
LES are busy. Your message will be transmitted when a circuit
becomes clear.
Displays communication charge. See paragraph 2.6.1.
Edit Transmit EGC
Transmit
1. Transmit Message
2. Cancel
Priority Normal
3. Request Delivery Status
Message File Message now being edited
Station Name
Destination Type TELEX
Prefix Code
Country/Ocean Code
Station ID
Modem Type
Address
Subject
25 Char.
Attach File
LES ID
Option
Confirmation ON
Send Delay 00:00
Delivery Delay Immediate
Code IA5
[ TRANSMIT ]
Transmit message menu
Reports Logs Options
<[1] UNTITLED1>
Transmit Message
Size
Cost ********.**(US$)
[ Line 2/ 2 Col.
Setup Position StopAlarm
24
[Insert ]
1 ]