Chapter 6 Wan Setup; Introduction To Wan Setup; Cloning The Mac Address; Wan Setup - ZyXEL Communications ZyXEL ZyWALL 2WE User Manual

6.1

Introduction to WAN Setup

This chapter explains how to configure settings for your WAN port.
6.2

Cloning The MAC Address

The MAC address field allows users to configure the WAN port's MAC address by using either the factory
default or cloning the MAC address from a computer on your LAN. Once it is successfully configured, the
address will be copied to the rom file (ZyNOS configuration file). It will not change unless you change the
setting in menu 2 or upload a different rom file.
ZyXEL recommends that you clone the MAC address of a computer on your LAN
even if your ISP does not require MAC address authentication.
6.3

WAN Setup

From the main menu, enter 2 to open menu 2.
The following table contains instructions on how to configure your WAN setup.
WAN Setup
This chapter describes how to configure the WAN using menu 2.
Menu 2 - WAN Setup
MAC Address:
Assigned By= Factory default
IP Address= N/A

Figure 6-1 MAC Address Cloning in WAN Setup

ZyWALL 2 and ZyWALL 2WE
Chapter 6
WAN Setup
6-1