Resetting The Zywall; Figure 4-8 Example Xmodem Upload - ZyXEL Communications ZyXEL ZyWALL 2WE User Manual

Zyxel internet security gateway user's guide
Hide thumbs Also See for ZyXEL ZyWALL 2WE:
Table of Contents

Advertisement

ZyWALL 2 and ZyWALL 2WE
4.5

Resetting the ZyWALL

If you forget your password or cannot access the SMT menu, you will need to reload the factory-default
configuration file or use the RESET button the back of the ZyWALL. Uploading this configuration file
replaces the current configuration file with the factory-default configuration file. This means that you will
lose all configurations that you had previously and the speed of the console port will be reset to the default of
9600bps with 8 data bit, no parity, one stop bit and flow control set to none. The password will be reset to
"1234", also.
4.5.1
Uploading a Configuration File Via Console Port
Step 1.
Download the default configuration file from the ZyXEL FTP site, unzip it and save it in a folder.
Step 2.
Turn off the ZyWALL, begin a terminal emulation software session and turn on the ZyWALL
again. When you see the message "Press Any key to enter Debug Mode within 3 seconds", press
any key to enter debug mode.
Step 3.
Enter "y" at the prompt below to go into debug mode.
Step 4.
Enter "atlc" after "Enter Debug Mode" message.
Step 5.
Wait for "Starting XMODEM upload" message before activating Xmodem upload on your
terminal. This is an example Xmodem configuration upload using HyperTerminal.
Step 6.
Click Transfer, then Send File to display the following screen.
Step 7.
After successful firmware upload, enter "atgo" to restart the router.
4-8

Figure 4-8 Example Xmodem Upload

Type the configuration file's
location, or click Browse to
search for it.
Choose the Xmodem
protocol.
Then click Send.
Introducing the SMT

Advertisement

Table of Contents
loading

This manual is also suitable for:

Zywall 2

Table of Contents