ZyXEL Communications ZyXEL ZyWALL 2WE User Manual page 311

LABEL
Enter a port number in this field to define a port range. This port number must be
Local Port End greater than that specified in the previous field (or equal to it for configuring an individual
port).
Enter the beginning (static) IP address, in a range of computers behind the remote
Remote Address secure gateway. This address should be specific to the remote computer using the VPN
Start tunnel. If you wish to configure the tunnel for a single IP address, enter it in this field and
again in the Remote Address End field.
Enter the end (static) IP address, in a range of computers on behind the remote secure
Remote Address gateway. This address should be specific to the remote computer using the VPN tunnel.
End/Mask If you wish to configure the tunnel for a single IP address, enter it in both the Remote
Address Start field and here.
0 is the default and signifies any port. Type a port number from 0 to 65535. Some of the
Remote Port Start
most common IP ports are: 21, FTP; 53, DNS; 23, Telnet; 80, HTTP; 25, SMTP; 110,
POP3
Enter a port number in this field to define a port range. This port number must be
Remote Port End greater than that specified in the previous field (or equal to it for configuring an individual
port).
Enter the WAN IP address of your ZyWALL. The ZyWALL uses its current WAN IP
My IP Address address (static or dynamic) in setting up the VPN tunnel if you leave this field as 0.0.0.0.
The VPN tunnel has to be rebuilt if this IP address changes.
Select IP to identify this ZyWALL by its IP address.
Local ID Type Select DNS to identify this ZyWALL by a domain name.
Select E-mail to identify this ZyWALL by an e-mail address.
When you select IP in the Local ID Type field, type the IP address of your computer or
leave the field blank to have the ZyWALL automatically use its own IP address.
When you select DNS in the Local ID Type field, type a domain name (up to 31
characters) by which to identify this ZyWALL.
Local Content
When you select E-mail in the Local ID Type field, type an e-mail address (up to 31
characters) by which to identify this ZyWALL.
The domain name or e-mail address that you use in the Content field is used for
identification purposes only and does not need to be a real domain name or e-mail
address.
VPN/IPSec Setup
Table 27-8 Advanced
ZyWALL 2 and ZyWALL 2WE
IKE VPN Rule Setup
DESCRIPTION
27-17