Table 10-4 Remote Node Network Layer Options Menu Fields - ZyXEL Communications ZyXEL ZyWALL 2WE User Manual
Zyxel internet security gateway user's guide
Hide thumbs
Also See for ZyXEL ZyWALL 2WE:
- Compact manual (42 pages) ,
- Specifications (2 pages) ,
- User manual (614 pages)
Table of Contents
Advertisement
ZyWALL 2 and ZyWALL 2WE
Table 10-4 Remote Node Network Layer Options Menu Fields
FIELD
IP Address
If your ISP did not assign you an explicit IP address, press [SPACE
Assignment
BAR] and then [ENTER] to select Dynamic; otherwise select Static
and enter the IP address & subnet mask in the following fields.
(Rem) IP
If you have a Static IP Assignment, enter the IP address assigned to
Address
you by your ISP.
(Rem) IP
If you have a Static IP Assignment, enter the subnet mask assigned to
Subnet Mask
you.
Gateway IP
This field is applicable to Ethernet encapsulation only. Enter the
Addr
gateway IP address assigned to you if you are using a static IP
address.
My WAN
This field is applicable to PPPoE and PPTP encapsulations only. Some
Addr
implementations, especially the UNIX derivatives, require the WAN link
to have a separate IP network number from the LAN and each end
must have a unique address within the WAN network number. If this is
the case, enter the IP address assigned to the WAN port of your
ZyWALL.
Note that this is the address assigned to your local ZyWALL, not the
remote router.
Network
Press [SPACE BAR] and then [ENTER] to select either Full Feature,
None or SUA Only. See the NAT chapter for a full discussion on this
Address
Translation
feature.
Metric
Enter a number from 1 to 15 to set this route's priority among the
ZyWALL's routes. The smaller the number, the higher priority the route
has.
Private
This field is valid only for PPTP/PPPoE encapsulation. This parameter
determines if the ZyWALL will include the route to this remote node in
its RIP broadcasts. If set to Yes, this route is kept private and not
included in RIP broadcast. If No, the route to this remote node will be
propagated to other hosts through RIP broadcasts.
RIP Direction
Press [SPACE BAR] and then [ENTER] to select the RIP direction from
Both/ None/In Only/Out Only. See the LAN Setup chapter for more
information on RIP. The default for RIP on the WAN side is None. It is
recommended that you do not change this setting.
Version
Press [SPACE BAR] and then [ENTER] to select the RIP version from
RIP-1/RIP-2B/RIP-2M or None.
10-8
DESCRIPTION
EXAMPLE
Dynamic
(default)
SUA Only
(default)
1
No
None
(default)
N/A
Remote Node Setup
Advertisement
Table of Contents
Troubleshooting
