ZyXEL Communications ZyXEL ZyWALL 2WE User Manual page 415

LOG MESSAGE
!! Invalid IP <IP start>/<IP end>
!! Remote IP <IP start> / <IP end>
conflicts
!! Active connection allowed
exceeded
!! IKE Packet Retransmit
!! Failed to send IKE Packet
!! Too many errors! Deleting SA
!! Phase 1 ID type mismatch
!! Phase 1 ID content mismatch
!! No known phase 1 ID type
found
Peer ID: IP address type <IP
address>
vs. My Remote <IP address>
Log Descriptions
Chart Q-10 Sample IKE Key Exchange Logs
DESCRIPTION
The peer's "Local IP Addr" range is invalid.
If the security gateway is "0.0.0.0", the ZyWALL will
use the peer's "Local Addr" as its "Remote Addr". If a
peer's "Local Addr" range conflicts with other
connections, then the ZyWALL will not accept VPN
connection requests from this peer.
The ZyWALL limits the number of simultaneous Phase
2 SA negotiations. The IKE key exchange process fails
if this limit is exceeded.
The ZyWALL did not receive a response from the peer
and so retransmits the last packet sent.
The ZyWALL cannot send IKE packets due to a
network error.
The ZyWALL deletes an SA when too many errors
occur.
The ID type of an incoming packet does not match the
local's peer ID type.
The ID content of an incoming packet does not match
the local's peer ID content.
The ID type of an incoming packet does not match any
known ID type.
The IP address type or IP address of an incoming
packet does not match the peer IP address type or IP
address configured on the local router. The log
displays the IP address type and IP address of the
incoming packet.
The IP address type or IP address of an incoming
packet does not match the peer IP address type or IP
address configured on the local router. The log
displays this router's configured remote IP address
type or IP address that the incoming packet did not
match.
ZyWALL 2 and ZyWALL 2WE
83