Wan Setup; Figure 2-11 Menu 2 - Wan Setup; Table 2-6 Wan Setup Menu Fields - ZyXEL Communications Prestige 314 User Manual

Prestige 314 Broadband Sharing Gateway with 4-Port Switch
If you have a private WAN IP address, then you can not use Dynamic DNS.
2.8

WAN Setup

This section describes how to configure the WAN using Menu 2 – WAN Setup. From the main menu, enter
2 to display menu 2.
ZyXEL recommends you configure this menu even if your ISP does not require
Press Space Bar to Toggle
The MAC address field allows users to configure the WAN port's MAC Address by either using the factory
default or cloning the MAC address from a workstation on your LAN. Once it is successfully configured, the
address will be copied to the rom file (ZyNOS configuration file). It will not change unless you change the
setting in menu 2 or upload a different rom file.
The following table contains instructions on how to configure your WAN setup.
FIELD
MAC Address
Assigned By Press the [SPACE BAR] to choose one of two methods to assign a
MAC Address. Choose Factory Default to select the factory assigned
default MAC Address. Choose IP Address attached on LAN to use
the MAC Address of that workstation whose IP you give in the
following field.
This field is applicable only if you choose the IP Address attached
IP Address
on LAN method in the Assigned By field above. Enter the IP
2-14
MAC address authentication.
Menu 2 - WAN Setup
MAC Address:
Assigned By= Factory default
IP Address= N/A
Press ENTER to Confirm or ESC to Cancel:
Figure 2-11 Menu 2 — WAN Setup

Table 2-6 WAN Setup Menu Fields

DESCRIPTION
Hardware Installation & Initial Setup
EXAMPLE
IP Address
attached on
LAN
192.168.1.33