ZyXEL Communications P8802T User Manual page 86

Chapter 4 WAN
Figure 22 WAN Configuration: Service Type
Figure 23 The following table describes the labels in this screen.
Table 19 WAN Configuration: Service Type
LABEL
Select WAN
service type
Enter Service
Description
Rate Limit
Tag VLAN ID for
egress packets
Enter 802.1P
Priority
Enter 802.1Q
VLAN ID
86
DESCRIPTION
Select the method of encapsulation used by your ISP.
Choices are PPP over Ethernet (PPPoE), IP over Ethernet and Bridging.
Specify a name for this connection or use the automatically generated one.
Enter the maximum transmission rate in Kbps for traffic sent through the WAN connection.
Otherwise, leave this field blank to disable the rate limit.
This field is not available for an ATM connection if QoS is disabled in the DSL ATM Interface
Configuration.
Select this option to add the VLAN tag (specified below) to the outgoing traffic through this
connection.
This field is available when the layer-2 interface is in VLANMUX mode.
IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into a MAC-layer
frame that contains bits to define class of service.
Type the IEEE 802.1p priority level (from 0 to 7) to add to traffic through this connection.
The greater the number, the higher the priority level.
This field is available when the layer-2 interface is in VLANMUX mode.
Type the VLAN ID number (from 1 to 4094) for traffic through this connection.
This field is available when the PTM interface is in VLANMUX mode.
Basic Home Station VDSL2 P8802T User's Guide