ZyXEL Communications P8802T User Manual page 84

Chapter 4 WAN
Figure 20 WAN Service
The following table describes the labels in this screen.
Table 17 WAN Service
LABEL
Interface
Description
Type
Vlan8021p
VlanMuxId
ConnId
Igmp
NAT
IPv6
Mld
Remove
Modify
Add
84
DESCRIPTION
This shows the name of the interface used by this connection.
A default name ipoa*, pppoa*, atm* or ptm* indicates the DSL port. ppp* indicates a PPP
connection through any one of the WAN interfaces.
The number after the dot (.) represents the VLAN ID number assigned to traffic sent through
this connection. The number after the underscore (_) represents the index number of
connections through the same interface.
(null) means the entry is not valid.
This is the service name of this connection.
0 and 35 or 0 and 1 are the default VPI and VCI numbers. The last number represents the
index number of connections over the same PVC or the VLAN ID number assigned to traffic
sent through this connection.
(null) means the entry is not valid.
This shows the method of encapsulation used by this connection.
This indicates the 802.1P priority level assigned to traffic sent through this connection. This
displays N/A when there is no priority level assigned.
This indicates the VLAN ID number assigned to traffic sent through this connection. This
displays N/A when there is no VLAN ID number assigned.
This shows the index number of each connection. This displays N/A when the interface used
by the connection is in Default Mode.
This shows whether IGMP (Internet Group Multicast Protocol) is activated or not for this
connection. IGMP is not available when the connection uses the bridging service.
This shows whether NAT is activated or not for this interface. NAT is not available when the
connection uses the bridging service.
This shows whether IPv6 is activated or not for this connection. IPv6 is not available when the
connection uses the bridging service.
This shows whether Multicast Listener Discovery (MLD) is activated or not for this connection.
MLD is not available when the connection uses the bridging service.
Select an interface and click the Remove button to delete it. You cannot remove a layer-2
interface when a WAN service is associated with it.
Click the Edit icon to configure the WAN connection.
Click the Remove icon to delete the WAN connection.
Click Add to create a new connection.
Basic Home Station VDSL2 P8802T User's Guide