Table of Contents
Advertisement
Chapter 14 Wireless
14.7.6 Preamble Type
Preamble is used to signal that data is coming to the receiver. Short and long refer to the length of
the synchronization field in a packet.
Short preamble increases performance as less time sending preamble means more time for sending
data. All IEEE 802.11 compliant wireless adapters support long preamble, but not all support short
preamble.
Use long preamble if you are unsure what preamble mode other wireless devices on the network
support, and to provide more reliable communications in busy wireless networks.
Use short preamble if you are sure all wireless devices on the network support it, and to provide
more efficient communications.
Use the dynamic setting to automatically use short preamble when all wireless devices on the
network support it, otherwise the VDSL Router uses long preamble.
Note: The wireless devices MUST use the same preamble mode in order to communicate.
14.7.7 WiFi Protected Setup (WPS)
Your VDSL Router supports WiFi Protected Setup (WPS), which is an easy way to set up a secure
wireless network. WPS is an industry standard specification, defined by the WiFi Alliance.
WPS allows you to quickly set up a wireless network with strong security, without having to
configure security settings manually. Each WPS connection works between two devices. Both
devices must support WPS (check each device's documentation to make sure).
Depending on the devices you have, you can either press a button (on the device itself, or in its
configuration utility) or enter a PIN (a unique Personal Identification Number that allows one device
to authenticate the other) in each of the two devices. When WPS is activated on a device, it has two
minutes to find another device that also has WPS activated. Then, the two devices connect and set
up a secure network by themselves.
14.7.7.1 Push Button Configuration
WPS Push Button Configuration (PBC) is initiated by pressing a button on each WPS-enabled
device, and allowing them to connect automatically. You do not need to enter any information.
Not every WPS-enabled device has a physical WPS button. Some may have a WPS PBC button in
their configuration utilities instead of or in addition to the physical button.
Take the following steps to set up WPS using the button.
Ensure that the two devices you want to set up are within wireless range of one another.
1
Look for a WPS button on each device. If the device does not have one, log into its configuration
2
utility and locate the button (see the device's User's Guide for how to do this - for the VDSL Router,
see
Section 14.5 on page
Press the button on one of the devices (it doesn't matter which). For the VDSL Router you must
3
press the Wifi button for 10 seconds.
192
184).
Basic Home Station VDSL2 P8802T User's Guide
Advertisement
Table of Contents
