Add Static Route - ZyXEL Communications P8802T User Manual

The following table describes the labels in this screen.
Table 46 Static Route
LABEL
IP Version
DstIP/
PrefixLength
Gateway
Interface
Metric
Remove
Add

9.3.1 Add Static Route

Use this screen to add a static route. Click Add in the Static Route screen to display the following
screen.
Figure 53 Static Route: Add
The following table describes the labels in this screen.
Table 47 Static Route: Add (Sheet 1 of 2)
LABEL
IP Version
Destination IP
address/prefix
length
Interface
Basic Home Station VDSL2 P8802T User's Guide
DESCRIPTION
This displays whether the entry uses IPv4 or IPv6.
This specifies the IP network address and prefix length of the final destination. Routing is
always based on network number.
This is the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway helps forward packets to
their destinations.
This is the interface this static route uses to forward traffic for the listed destination
address.
The metric represents the "cost of transmission". A router determines the best route for
transmission by choosing a path with the lowest "cost". The smaller the number, the lower
the "cost".
Select entries and click the Remove button to delete them.
Click this to configure a new static route.
DESCRIPTION
Select whether your IP type is IPv4 or IPv6.
Enter the IPv4 or IPv6 address and network length of the final destination.
Select the interface through which this static route sends traffic.
Chapter 9 Routing
141