Table of Contents
Advertisement
It covers two WPS methods to set up the wireless client settings:
• Push Button Configuration (PBC) - simply press a button. This is the easier method.
• PIN Configuration - enter a wireless client's Personal Identification Number (PIN) in the VDSL
Router.
Push Button Configuration (PBC)
Make sure that your VDSL Router is on and your notebook is within range of the wireless signal.
1
Make sure that you have installed the wireless client driver and utility in your notebook.
2
In the wireless client utility, go to the WPS setting page. Enable WPS and press the Wifi button
3
(Start or Wifi button).
Push and hold the Wifi button located on the VDSL Router's rear panel for 10 seconds.
4
Note: It doesn't matter which device's button you press first. You must press the second
button within two minutes of pressing the first one.
Note: The WPS button in the Web Configurator screens also has the same function as the
one on the VDSL Router rear panel: use either.
The VDSL Router sends the wireless network settings to the wireless client. This may take up to two
minutes. Afterwards the wireless client can communicate with the VDSL Router securely.
The following figure shows an example of how to set up a wireless network and its security by
pressing a button on both VDSL Router and wireless client.
Basic Home Station VDSL2 P8802T User's Guide
Chapter 2 User Setup Guide
23
Advertisement
Table of Contents
