Table of Contents
Advertisement
Chapter 4
broadcast or multicast messages for associated clients, it sends the next DTIM with a
DTIM Interval value. You can specify the value between 1-255 Beacon Intervals. The
default value is 1, which indicates the DTIM Interval is the same as Beacon Interval.
•
Enable WMM
- WMM function can guarantee the packets with high-priority messages
being transmitted preferentially. It is strongly recommended to enable this function.
•
Enable Short GI
- It is recommended to enable this function, for it will increase the
data capacity by reducing the guard interval time.
•
Enable AP Isolation
wireless stations cannot access each other through WLAN. This function will be
disabled if WDS/Bridge is enabled.
4. 3. 6.
Wireless Statistics
1. Visit http://tplinkwifi.net, and log in with the username and password you set for
the router.
2. Go to
Advanced
sent and received by each client device connected to the router.
•
MAC Address
- The MAC address of the connected wireless client.
•
Current Status
- The running status of the connected wireless client.
•
Received Packets
•
Sent Packets
- Packets sent by the wireless client.
•
Configure
- The button is used for loading the item to the Wireless MAC Filtering list.
•
Allow
- If the Wireless MAC Filtering function is enabled, click this button to
allow the client to access your network.
•
Deny
- If the Wireless MAC Filtering function is enabled, click this button to
deny the client to access your network.
- This function isolates all connected wireless stations so that
>
Wireless 2.4GHz
- Packets received by the wireless client.
Configure the Router in Standard Router Mode
>
Wireless Statistics
to check the data packets
44
Advertisement
Table of Contents
