TP-Link TP-TL-WR1043N User Manual page 154

Chapter 5
2. Visit http://tplinkwifi.net, and log in with the username and password you set for
the router.
3. Go to Advanced
4. Click Browse to locate the downloaded firmware file, and click Upgrade.
5. Wait a few minutes for the upgrade and reboot to complete.
5. 14. 5. Factory Defaults
1. Visit http://tplinkwifi.net, and log in with the username and password you set for
the router.
2. Go to Advanced
to the default values.
• The default Username: admin
• The default Password: admin
• The default
• The default
5. 14. 6. Backup & Restore
The configuration settings are stored as a configuration file in the router. You can
backup the configuration file in your computer for future use and restore the router to
the previous settings from the backup file when needed.
1. Visit http://tplinkwifi.net, and log in with the username and password you set for
the router.
> System Tools > Firmware
> System Tools > Factory
IP Address: 192.168.0.1
Subnet Mask: 255.255.255.0
Configure the Router in Hotspot Router Mode
Upgrade.
Defaults. Click Restore to reset all settings
151