Cabling A Ctp150 Interface Module; Table 11: Required Cables - Juniper CTP150 Manual

CTP150 Platform Hardware Documentation
Related
Documentation

Cabling a CTP150 Interface Module

Related
Documentation
58
No. 2 Phillips screwdriver
Ground wires—We recommend a minimum of 18-AWG ground wire for AC and
DC-powered versions, if applicable.
Two #10 kep nuts (supplied) to connect the ground (earth) wire to the ground terminal.
Power module wiring—We recommend a minimum of 18-AWG wire for the device with
a dual stud terminal lug with 5/8-inch spacing.
Consider the distance from the connection point and the configuration of the device
when determining the size of wire used.

Table 11: Required Cables

Connection
Management connection between the processor
module and the LAN
Management connection between the processor
module and a management console
Direct connections to interface modules
Cabling the CTP150 Platform Overview on page 57
Cabling a CTP150 Interface Module on page 58
To install a cable in an interface module:
Ground yourself by using an antistatic wrist strap or other device, and connect it to
1.
an ESD grounding jack, if available, or another grounding device.
Remove the dust cover that protects the cable connectors.
2.
Slide the cable as far as you can into the module until it clicks into place.
3.
Gently pull the cable to confirm that it is inserted correctly.
4.
Go on to "Before You Power On the CTP150 Device" on page
5.
Required Tools, Wires, and Cables for the CTP150 Platform on page 57
Setting Up Management Access to the CTP150 Platform on page 61
CTP150 Console Port Setup
Using SSH to Access the CTP Platform on page 62
Port and Cable Used
One 10/100Base-T Ethernet management port
with an RJ-45 connector.
One RS-232 port with a DB-9 connector for
VT100 management access.
Cables vary depending on module.
65.
Copyright © 2015, Juniper Networks, Inc.