Using Hyperterminal To Access The Ctp150 Device; Using Ssh To Access The Ctp Platform - Juniper CTP150 Manual

CTP150 Platform Hardware Documentation
Related
Documentation

Using HyperTerminal to Access the CTP150 Device

Related
Documentation

Using SSH to Access the CTP Platform

62
You can now power on the device. See Powering On and Initially Configuring the CTP150
3.
Device.
Setting Up Management Access to the CTP150 Platform on page 61
Using HyperTerminal to Access the CTP150 Device on page 62
If your console uses a version of Microsoft Windows (such as Windows XP or Windows
NT 4.0) that supports the HyperTerminal application, you can access the device through
HyperTerminal.
Click the Start button and select
1.
.
HyperTerminal
In the HyperTerminal window, select
2.
In the Connection Description dialog box, enter a name for your device in the Name
3.
field.
Select any icon to represent your terminal emulation, and click
4.
In the Connect To dialog box, in the Connect using field, select the appropriate COM
5.
port to use (for example,
In the COM1 Properties dialog box, select the following settings:
6.
Bits per second: 9600
Data bits: 8
Parity: None
Stop bits: 1
Flow control: Xon/Xoff
Click OK .
7.
Setting Up Management Access to the CTP150 Platform on page 61
Connecting Directly to the CTP150 Platform on page 61
When you have configured an IP address for the CTP150 device, you can run SSH from
a remote host to access the device through its Ethernet port. To connect the Ethernet
port to the network:
Connect an Ethernet RJ-45 cable to one of the two Ethernet ports on the front panel
1.
of the CTP150 chassis.
Connect the other end of the cable to the appropriate Ethernet network for an
2.
out-of-band connection.
Programs, Accessories, Communications, and
HyperTerminal
), and click .
COM1 OK
.
.
OK
Copyright © 2015, Juniper Networks, Inc.