Table of Contents
Advertisement
CHAPTER 13
Cabling
Cabling the CTP150 Platform Overview
Related
Documentation
Required Tools, Wires, and Cables for the CTP150 Platform
Copyright © 2015, Juniper Networks, Inc.
Cabling the CTP150 Platform Overview on page 57
Required Tools, Wires, and Cables for the CTP150 Platform on page 57
Cabling a CTP150 Interface Module on page 58
CTP150 Fast Ethernet Cables on page 59
Cabling the CTP platform requires the following main tasks:
Familiarize yourself with the module ports, and ensure that you have the cables and
1.
wires needed to complete each cabling procedure.
Read and understand all safety warnings. (See
2.
on page
35.)
Connect timing ports.
3.
Connect grounding wires to the chassis.
4.
Connect the power cables from the power source to the power supply.
5.
Connect the interface modules to their appropriate network interface.
6.
CTP Cabling Recommendations on page 20
Required Tools, Wires, and Cables for the CTP150 Platform on page 57
Setting Up Management Access to the CTP150 Platform on page 61
CTP150 Console Port Setup
Cabling a CTP150 Interface Module on page 58
Cabling your device takes only a few minutes. You need the following items and the
cables listed in
Table 11 on page 58
1/8-inch flathead screwdriver
3/8-inch wrench or 3/8-inch nut-driver
"CTP Safety Guidelines and Warnings"
for proper installation:
57
Advertisement
Table of Contents
Troubleshooting
