Juniper CTP150 Manual page 83

Copyright © 2015, Juniper Networks, Inc.
IP address of the interface—Enter the IP address of the selected interface, or accept
5.
the loopback address (127.0.0.1) by default.
Netmask of the IP address—Enter the netmask (such as 255.255.255.128), or accept
6.
255.255.255.0 as the default.
Gateway IP address—Enter the IP address of the gateway, or accept the local address
7.
(127.0.0.1) as the default
Maximum transmission unit (MTU)—Enter the MTU in bytes, or accept 1500 bytes as
8.
the default.
Static routes added to the default interface, if any.
9.
Date and time GMT (more precisely, UTC)—Enter these separately in digits for the
10.
month, day, hour, and minutes in Coordinated Universal Time (UTC), or accept the
internal settings.
The device goes into startup mode.
For example:
***** First boot of this flash. Setting up basic system configuration. *****
*********** Setting up the root password ************
Changing root's password!
Changing password for user root.
New password:
Retype new password:
BAD PASSWORD: it is too short
passwd: all authentication tokens updated successfully.
Backing up /etc to nonvolatile storage..
************** Setting up the network ***************
Configure supported protocols:
0) IPv4 Only
1) IPv6 Only
2) IPv4 & IPv6
Please select your option (rtn for 0):
There are 2 ethernet devices available for use. The default device
is the device through which the default gateway can be accessed.
Ctp circuits can run over any ethernet device, default or not.
A default device must be configured, other devices may be configured
and enabled, or disabled. Here is a list to the available devices
and their descriptions:
eth0: 10/100/1000 Copper (right)
eth1: 10/100/1000 Copper (left)
What device would you like to make the IPV4 default device? (rtn for eth0):
OK, eth0 (10/100/1000 Copper (right)) will be configured as IPV4 default device.
Please input the hostname (return for (none)): ctp150bot
===== Configuration for eth0 (default device):
Please input the ip (return for 127.0.0.1): 10.3.206.10
Please input the netmask (return for 255.255.255.0): 255.255.0.0
Please input the gateway (return for 127.0.0.1): 10.3.0.1
Please input the mtu in bytes (return for 1500):
Chapter 15: Powering On and Initially Configuring the CTP150 Platform
67