Powering On The Ctp150 Device; Configuring The First Boot Script For The Ctp150 Device - Juniper CTP150 Manual

CTP150 Platform Hardware Documentation

Powering On the CTP150 Device

Related
Documentation

Configuring the First Boot Script for the CTP150 Device

66
In this procedure we assume that the device is already connected to a power source.
For specifications on the electrical requirements for the device, see
Specifications" on page 13.
CAUTION: Evaluate the overall loading of the branch circuit before you install
any equipment into a rack.
To power on the device:
Verify that the power source is operational.
1.
Inspect all grounding and power connections to the device chassis.
2.
Confirm that all cable connections are secure.
3.
Switch any available power switches to ON.
4.
Monitor LEDs to verify that the device is booting properly.
5.
The device goes through a boot process. When a prompt appears on the console, the
device is ready to be configured. If the device is new, it boots to a first boot script. If
the device is already operational, it boots to a login prompt.
During initial power-on, the components of the platform run boot code, go through a
series of self-diagnostic tests, and synchronize with each other.
When the tests are complete, use the LEDs on each module to determine the status of
the device. Observe the module LEDs on the front or rear components.
Before You Power On the CTP150 Device on page 65
Powering Off the CTP Platform on page 68
For the first-time boot process, there is a series of login prompts that require the following
settings:
Default username (ctp) and password (ctp). (We recommend that you change the
1.
root password after entering the default.)
Supported protocol or protocols—(0) IPv4 only, (1) IPv6 only, or (2) IPv4 and IPv6.
2.
Enter the appropriate number value.
Default interface—From the list of available devices, such as eth0 and eth1 (or more),
3.
enter the one to be the default.
Hostname of the device.
4.
"CTP150 Platform
Copyright © 2015, Juniper Networks, Inc.