Powering Off The Ctp Platform - Juniper CTP150 Manual

CTP150 Platform Hardware Documentation
Related
Documentation

Powering Off the CTP Platform

68
Add route to interface eth0 [n]
======================================
=== OS Security level set to LOW ===
======================================
Backing up /etc to nonvolatile storage..
Backing up /usr/local to nonvolatile storage..
************** Setting up date/time *****************
Setting the date (GMT). Please input the year [2008-2020] (return for 2010):
Setting the date (GMT). Please input the month [1-12] (return for 11):
Setting the date (GMT). Please input the day [1-31] (return for 14):
Setting the date (GMT). Please input the hour [0-23] (return for 16):
Setting the date (GMT). Please input the minute [0-59] (return for 41):
INIT: Entering runlevel: 3
Entering non-interactive startup
Powering On the CTP150 Device on page 66
Use one of the following methods to power off the device:
Using the halt Command at the CTP Command Line
Using the CTP Menu
To power off the CTP platform from the CTP command line:
Before you power off the device, enter the halt command to temporarily suspend the
device's operation.
CAUTION: If you do not use the halt command before removing or powering
down the device, the device's CompactFlash card might become corrupted.
To power off the device from the CTP Menu:
From the Main Menu, select 5) Node Operations.
1.
From the Node Operations Menu, select 10) Powerdown Node.
2.
Copyright © 2015, Juniper Networks, Inc.