Accessing The Ctp150 Platform; Setting Up Management Access To The Ctp150 Platform; Connecting Directly To The Ctp150 Platform - Juniper CTP150 Manual

CHAPTER 14

Accessing the CTP150 Platform

Setting Up Management Access to the CTP150 Platform

Related
Documentation

Connecting Directly to the CTP150 Platform

Copyright © 2015, Juniper Networks, Inc.
Setting Up Management Access to the CTP150 Platform on page 61
Connecting Directly to the CTP150 Platform on page 61
Using HyperTerminal to Access the CTP150 Device on page 62
Using SSH to Access the CTP Platform on page 62
Before you power on the device for the first time, you need to physically connect a console
(PC, Macintosh, or UNIX workstation) to the device's
connection, you communicate with the CTP150 device during the power-on process to
set an IP address and initially configure the device.
After you configure an IP address on the CTP150 device, you can access the device
remotely through the Ethernet port by running SSH from a remote console.
Connecting Directly to the CTP150 Platform on page 61
Using HyperTerminal to Access the CTP150 Device on page 62
Using SSH to Access the CTP Platform on page 62
You can connect a console terminal (PC, Macintosh, or UNIX workstation) directly to the
port on the CTP150 device. Initial configuration of the CTP device requires a
CONSOLE
direct connection. Once you configure an IP address for the device, you can connect to
the device remotely.
To communicate with the device through the console, you must have a terminal emulation
program running on your console terminal. You can use any terminal emulation program,
such as HyperTerminal. A UNIX workstation can use the emulator TIP.
To connect a console directly to the CTP150 device:
Connect the RJ-45 connector to the
1.
Connect the crossover adapter connector to your console's serial port.
2.
port. Through this
CONSOLE
CONSOLE port.
61